Mixing Instructions for Super Fast Pro 2:1 Table Top Epoxy Resin

Tip:  If your resin is cold you can warm Part A only in a tub of warm (not hot) water for 5-10 minutes.  This will make it easier to mix and release bubbles.

Equipment:  scales, plastic cups for mixing, stir sticks, plastic spreader, torch, gloves, safety glasses, respirator.

Steps for mixing Table Top Super Fast Pro Epoxy Resin:

1. Mix ratio is 2:1 by weight - exactly weigh Part A and Part B 
2. Pour Part B into your mixing container first, then add Part A.  Slowly mix Part A and Part B together for 3 to 4 minutes until the resin becomes clear from cloudy - it's a good idea to set a timer.
3. Ensure you scrape the sides and bottom to mix thoroughly.  Mixing too fast will introduce more bubbles, so mix at a steady speed.
   
4. Transfer the resin into a second container and stir for 1 more minute
5. Do not leave the mixed resin in the cup for longer than 5 minutes as it will generate heat and could start to set in the container (smaller volumes ie 100 ml or less may last longer).
6. Apply to your project and spread evenly
7. Quickly torch, if necessary, do not over torch and do not torch after 5 minutes  
8. Protect your work from dust
9. In about 4-6 hours your project should be hard to the touch, after 72 hours it will be fully cured.
10. Keeping your room at a consistent temperature and humidity will improve results.  We recommend a room temperature of 24 degrees celcius and humidity less than 60% - preferably 50%.

Note: 

1. It is not recommended to add mica powder to the table top resin as it may cause extra bubbles.  Our 3:1 art resin is designed specifically for mica powders.
2. We recommend curing your finished work for 5-7 days before covering and shipping

Our Serenity Hill Designz Table Top SUPER FAST PRO Epoxy Resin is the perfect resin for bar and benchtops, flood coats and artwork.